DPA 4018 Supercardioid Gooseneck Microphone
PRICE - Rs. 2,66,319
DPA 4018F supercardioid gooseneck microphone: floor stand solution for stage voice or instruments, XLR and P48, five lengths from 20 to 122 cm. Available in India from Shivansh Electronics, Kolkata, West Bengal, India.
VISUAL GUIDE — See Every Photo, Spec & Setup Step (PDF)
The price shown is inclusive of all taxes. Contact / WhatsApp +91 89818 07755 / +91 91477 00677 to check if any offers or additional discounts are available. If available, we will gladly share a coupon code that you can apply at checkout for the best price. All payments are processed securely through Razorpay, our trusted payment gateway partner.
Acoustics
| Directional pattern | Supercardioid |
| Principle of operation | Pressure gradient |
| Cartridge type | Pre-polarised condenser |
| Frequency response | 20 Hz - 20 kHz |
| Effective frequency range, ±2 dB, at 30 cm (11.8 in) | 40 Hz - 18 kHz |
| Sensitivity, nominal, ±2 dB at 1 kHz | 12 mV/Pa; -38.4 dB re. 1 V/Pa |
| Equivalent noise level, A-weighted | Typ. 16 dB(A) re. 20 µPa (max. 19 dB(A)) |
| Equivalent noise level, ITU-R BS.468-4 | Typ. 23 dB (max. 26 dB) |
| Distortion, THD < 1 % | 134 dB SPL RMS, 137 dB SPL peak |
| Dynamic range | Typ. 121 dB |
| Max. SPL, THD 10 % | 142 dB SPL peak |
| Matching tolerance (frequency response and sensitivity) | ±1 dB |
| Phase deviation for kit | < 10° |
Electrical
| Rated output impedance | 100 Ω |
| Minimum load impedance | 2 kΩ |
| Cable drive capability | 100 m (328 ft) |
| Output balance principle | Impedance balancing |
| Common mode rejection ratio (CMRR) | > 40 dB |
| Power supply (for full performance) | P48 phantom power |
| Current consumption | 3.5 mA |
| Maximum output voltage, RMS | 2.2 V |
| Connector | XLR-3M. Pin 1: shield, pin 2: signal + phase, pin 3: - phase |
| Polarity | +V at pin 2 for positive sound pressure |
Physical
| Microphone diameter | 19 mm (0.75 in) |
| Capsule diameter | 19 mm (0.75 in) |
| Length | Capsule 23 mm (0.9 in); boom poles 20 cm (8 in), 32 cm (13 in), 47 cm (18 in), 77 cm (30 in), 122 cm (48 in) |
| Colour | Matte black |
| Temperature range | -40 °C to 45 °C (-40 °F to 113 °F) |
| Relative humidity | Up to 90 % |
Versions
| 4018-DF-G-B01-015 | 20 cm (8 in) boom, full gooseneck |
| 4018-DF-G-B01-030 | 32 cm (13 in) boom, top and bottom gooseneck |
| 4018-DF-G-B01-045 | 47 cm (18 in) boom, top and bottom gooseneck |
| 4018-DF-G-B01-075 | 77 cm (30 in) boom, top and bottom gooseneck |
| 4018-DF-G-B01-120 | 122 cm (48 in) boom, top and bottom gooseneck |
Product overview
The DPA 4018F gooseneck microphone is a complete microphone floor stand solution offering a high-quality stage voice or instrument mic in an elegant and exclusive design.
This solution uses the MMC4018 Capsule, which has a highly directional supercardioid pickup pattern with a smooth and uniform off-axis frequency response.
The supercardioid shape is frequency independent, securing an identical sound colour around the microphone. The usual rear lobe of a supercardioid is minimised on this capsule, so it is much more isolated, without sudden frequency dependent peaks and dips.
Thanks to its modular nature, the 4018 Supercardioid Microphone Boom can be combined with podium booms of 15, 30 or 45 cm (6, 12 or 18 in), and the long booms of 75 or 120 cm (30 or 48 in) make a high-quality stage voice mic with visual elegance on floor stands, together with the dedicated DPA accessories.
The 4018F comes in five lengths: 20 cm (8 in), 32 cm (13 in) and 47 cm (18 in) booms intended for podium solutions, and 77 cm (30 in) and 122 cm (48 in) for floor stand applications. It connects with an XLR-3M connector and runs on P48 phantom power.
| Pre-polarised condenser | Supercardioid |
| Dynamic range, typical | 121 dB |
| Max. SPL, THD 10 %, peak | 142 dB |
| 20 to 122 cm, XLR | 5 lengths |
Key features
- Low noise and natural voice
- Highly directional for high isolation
- Uniform, frequency independent directionality
- Exclusive, elegant design
- Integrated shock-mounting in the floor base
- Rapidly stabilising microphone boom pole
- Modular flexibility: podium and long booms
- XLR-3M connector, P48 phantom power
Which length for which use
- 20 cm (8 in): a good length for ceiling mounting
- 32 cm (13 in): sometimes used for ceiling-mounted solutions
- 47 cm (18 in): often used for tabletop solutions
- 77 cm (30 in): often used for floor stand applications
- 122 cm (48 in): a taller floor stand option
Made for
- Stage voice microphone on a floor stand
- Instrument microphone on stage
- Podium and lectern solutions
- Tabletop and ceiling-mounted solutions
In the box
- 4018F gooseneck microphone in the length ordered
DPA 4018F: frequently asked questions
Which length of 4018F should I choose?
The 20 cm, 32 cm and 47 cm booms are intended for podium solutions (20 cm is a good length for ceiling mounting, 47 cm is often used on tables); the 77 cm and 122 cm versions are for floor stand applications.
What makes the supercardioid pattern special?
The supercardioid shape is frequency independent, securing an identical sound colour around the microphone, and the rear lobe is minimised on this capsule, so it is very isolated without sudden frequency dependent peaks and dips.
How is the 4018F powered and connected?
It has an XLR-3M connector (pin 2 signal + phase) and needs P48 phantom power; current consumption is 3.5 mA and it drives cables up to 100 m (328 ft).
Can it be used for instruments?
Yes. The 4018F is a complete microphone floor stand solution offering a high-quality stage voice or instrument mic.
Is the gooseneck modular?
Yes. The 4018 Supercardioid Microphone Boom can be combined with podium booms of 15, 30 or 45 cm, and with long booms of 75 or 120 cm for floor stands.
Where can I buy the DPA 4018F in India?
The DPA 4018F is available from Shivansh Electronics, Kolkata, West Bengal, India, with delivery across India.
Workflow 1: Stage voice microphone on a floor stand
Presenters, speakers and singers on stage.
Connections
| Connect | To |
|---|---|
| 4018F, 77 or 122 cm | Floor stand with integrated shock-mounted base |
| XLR-3M | Console input with P48 |
Setup
- Choose the 77 cm or 122 cm version for floor stand use.
- Set the boom and aim the capsule at the mouth.
- Connect the XLR and switch on P48.
- Set the gain.
Tip: The integrated shock-mounting in the floor base keeps handling noise away.
Workflow 2: Podium and lectern
Conference venues, lecture halls and houses of worship.
Connections
| Connect | To |
|---|---|
| 4018F, 20, 32 or 47 cm | Podium or lectern |
| XLR-3M | Mixer input with P48 |
Setup
- Pick a podium length: 20, 32 or 47 cm.
- Mount it on the podium and bend the gooseneck towards the speaker.
- Connect and set the gain.
Tip: The supercardioid pattern gives high isolation from the room.
Workflow 3: Instrument microphone on stage
Live engineers miking acoustic instruments.
Connections
| Connect | To |
|---|---|
| 4018F | Instrument position |
| XLR-3M | Stage box with P48 |
Setup
- Place the floor stand next to the instrument.
- Aim the capsule at the sound source.
- Connect and set the level.
Tip: Uniform, frequency independent directionality keeps the instrument natural.
Workflow 4: Ceiling-mounted solution
Installers covering meeting rooms and stages from above.
Connections
| Connect | To |
|---|---|
| 4018F, 20 or 32 cm | Ceiling mounting point |
| XLR-3M | Installed audio system with P48 |
Setup
- Use the 20 cm version (a good length for ceiling mounting) or 32 cm.
- Mount it and aim the capsule at the talking area.
- Run the XLR cable to the system.
Tip: Low noise keeps speech natural at a distance.
Workflow 5: Tabletop solution
Meeting and board rooms.
Connections
| Connect | To |
|---|---|
| 4018F, 47 cm | Table |
| XLR-3M | Conference mixer with P48 |
Setup
- Use the 47 cm version, often used on tables.
- Aim the gooseneck at the seat.
- Connect and set the gain.
Tip: The elegant design suits visible installations.
Workflow 6: Modular boom changes
Venues that use the microphone in several set-ups.
Connections
| Connect | To |
|---|---|
| 4018 Supercardioid Microphone Boom | Podium boom 15, 30 or 45 cm |
| Microphone Boom | Long boom 75 or 120 cm |
Setup
- Combine the microphone boom with the podium boom for lecterns.
- Change to a long boom for floor stand use.
- Reconnect via XLR with P48.
Tip: Modular flexibility lets one microphone serve several applications.
